Installation & Tech Tips
ALWAYS disconnect from the negative battery terminal before starting any 12volt install.
Watch for pinch points and things that could potentially sever or strip back insulation from the wire(s).
Always make sure you have all of the proper required tools before installing.
Soldering is the recommended way for joining wires together.
Heat shrink is also recommended for protecting and sealing previously soldered wire(s).
If experiencing fitment issues with LED replacements headlight, the locking collar or set screw (certain models) can be removed and placed inside of the headlight housing and locked in. After securing it in the housing, place the collar-less LED headlight back into the collar to complete the install.
When using the 3 watt little accent light, remember it is to be used in conjunction with a momentary switch. But if a constant ON condition is desired, a 50 ohm resistor should be installed in series with the light on the red power wire.